HP (Hewlett-Packard) 6L Printer User Manual


 
Copyright Information
© 1997 Hewlett-Packard Company
All Rights Reserved.
Reproduction, adaptation, or
translation without prior written
permission is prohibited, except
as allowed under the copyright
laws.
Part number: C3990-90901
First Edition, May 1997
Documentation Warranty
Statement
The information contained in this
document is subject to change
without notice.
Hewlett-Packard makes no
warranty of any kind with regard
to this material, including, but not
limited to, the implied warranties
of merchantability and fitness for
a particular purpose.
Hewlett-Packard shall not be
liable for errors contained herein
or for incidental or consequential
damage in connection with the
furnishing, performance, or use of
this manual.
Trademark Credits
Microsoft®, Windows® and
MS-DOS® are U.S.registered
trademarks of Microsoft
Corporation.
Material Safety Data Sheet
(MSDS)
The Toner Material Safety Data
Sheet (MSDS) can be obtained
by calling HP First at (800)
333-1917 or (208) 344-4809.
International customers should
refer to “Hewlett-Packard
Services Worldwide” at thefront
of this manual for appropriate
numbers and information.
FCC Regulations
This equipment has been tested
and found to comply with the
limits for a Class B digital device,
pursuant to Part 15 of the FCC
rules.These limits are designed
to provide reasonable protection
against harmful interference in a
residential installation.This
equipment generates, uses, and
can radiate radio frequency
energy, and if not installed and
used in accordance with the
instructions, may cause harmful
interference to radio
communications.However, there
is no guarantee that interference
will not occur in a particular
installation.If this equipment does
cause harmful interference to
radio or television reception,
which can be determined by
turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase separation between
equipment and receiver.
• Connect equipment to an outlet
on a circuit different from that to
which the receiver is connected.
Consult your dealer or an
experienced radio/TV technician.
Note: Any changes or
modifications to the printer not
expressly approved by HP could
void the user’s authority to
operate this equipment.
Use of a shielded interface
cable is required to comply
with the Class B limits of Part
15 of FCC rules.
Canadian DOC Regulations
Complies with Canadian EMC
Class B requirements.
<<Conforme á la classe B
des normes canadiennes do
compatibilité électromagnétiques.
<<CEM>>.>>