Filter
Top Products
Advanced Configuration and Management Guide
Table 12.3: CLI Display of VRRP or VRRPE Detailed Information (Continued)
dead-interval The configured value for the dead interval. The dead interval is the
number of seconds a Backup waits for a Hello message from the
Master for the VRID before determining that the Master is no longer
active.
If the Master does not send a Hello message before the dead interval
expires, the Backups negotiate (compare priorities) to select a new
Master for the VRID.
Note: If the value is 0, then you have not configured this parameter.
Note: This field does not apply to VRRP Owners.
current dead-interval The current value of the dead interval. his is the value actually in
use by this interface for the VRID.
Note: This field does not apply to VRRP Owners.
preempt-mode Whether the backup preempt mode is enabled.
Note: This field does not apply to VRRP Owners.
virtual ip address The virtual IP addresses that this VRID is backing up.
advertise backup The IP addresses of Backups that have advertised themselves to this
routing switch by sending Hello messages.
Note: Hello messages from Backups are disabled by default. ou
must enable the Hello messages on the Backup for the Backup to
advertise itself to the current Master. See “Hello Messages” on
page 12-4.
backup router <ip-addr> expires in
<time>
The IP addresses of Backups that have advertised themselves to this
Master by sending Hello messages.
The <time> value indicates how long before the Backup expires. A
Backup expires if you disable the advertise backup option on the
Backup or the Backup becomes unavailable. Otherwise, the Backup’s
next Hello message arrives before the Backup expires. The Hello
message resets the expiration timer.
An expired Backup does not necessarily affect the Master. However,
if you have not disabled the advertise backup option on the Backup,
then the expiration may indicate a problem with the Backup.
Note: This field applies only when Hello messages are enabled on
the Backups (using the advertise backup option).
next hello sent in <time> How long until the Backup sends its next Hello message.
Note: This field applies only when this routing switch is the Master
and the Backup is configured to send Hello messages (the advertise
backup option is enabled).
master router <ip-addr> expires in
<time>
The IP address of the Master and the amount of time until the
Master’s dead interval expires. If the Backup does not receive a Hello
message from the Master by the time the interval expires, either the IP
address listed for the Master will change to the IP address of the new
Master, or this routing switch itself will become the Master.
Note: This field applies only when this routing switch is a Backup.
This Field... Displays...
T
Y
12 - 24