Filter
Top Products
Installing the SAN Switch 2/8
35hp StorageWorks SAN Switch 2/8 Installation Guide
7. Attach the rear brackets to the front brackets as follows:
a. Position the right rear bracket (Item 4) inside the right front bracket (Item
8). See Figure 6.
b. Secure the brackets using four 6-32 x 5/16 inch screws (Item 3). See
Figure 6.
c. Adjust the brackets to the appropriate rack depth and tighten screws to a
torque of 9-inch pounds.
8. Repeat Steps 7a through 7c to attach the left rear bracket (Item 2) to the left
front bracket (Item 1).
9. Attach the right rear bracket (Item 4) to the right rear rack rail using two 10-32
x 3/8 inch screws (Item 5) and two retainer nuts (Item 6).
10. Repeat step 9 to attach the left rear bracket (Item 2) to the left rear rack rail.
11. Tighten all screws to a torque of 25-inch pounds.
12. Connect the SAN Switch 2/8 power cord to the power connector on the
switch. See Figure 7.
Figure 7: Connecting the power cord
SHR-2496B