Filter
Top Products
Installing the SAN Switch 2/8
56 hp StorageWorks SAN Switch 2/8 Installation Guide
4. Connect the cables to the SFPs as appropriate to the fabric topology, by
positioning each cable so that the key (the ridge on one side of the cable
connector) is aligned with the slot in the SFP. See Figure 17.
Figure 17: Inserting a cable into an SFP
Note: The cable is keyed so that it can only be inserted correctly into the SFP. If the
cable does not slide in easily, check the orientation.
Verifying Operation
After making the appropriate connections, as outlined in this chapter, use these
steps to verify that the switch is running properly.
1. Access your browser.
2. At the URL address window type, http://your switch IP
address.
3. Press Enter.
4. If connected properly, the name of your switch appears (in green) in the Web
browser window, indicating Healthy/OK.
SHR-2499B