Filter
Top Products
Installing the SAN Switch 2/8
42 hp StorageWorks SAN Switch 2/8 Installation Guide
Figure 11: Assembling the outer rails
5. Assemble each of the two inner rails (one on each side of the switch and
plenum) using eight #8-32 x 5/16 Phillips pan-head screws (with attached star
lock washers) and eight #8 flat washers as shown in Figure 12.
Caution: Do not use any other screws other than the eight that are provided.
Use of any longer lengths can cause damage to internal components of the
switch. Be sure to install the flat washers along with the pan-head screws.
Before tightening screws, make sure that the rails are centered to the overall
height of the switch.
1 Outer rail alignment pins 2 M5 torx screws
1
2
SHR-2560A