Filter
Top Products
Removal and Replacement Procedures
Maintenance and Service Guide 5–69
2. Disconnect the fan cable 1 from the system board.
3. Remove the following screws:
2 One Phillips PM2.5×3.0 screw that secures the expansion
port 2 bracket to the system board
3 Two slotted M1.5×9.0 screws on each side of the
expansion port 2 connector that secure the expansion
port 2 bracket to the system board
4 Two Phillips PM3.0×6.0 screws on each side of the
external monitor connector that secure the fan assembly
to the system board
Removing the Fan Assembly Screws