Filter
Top Products
Propagating the Kerberos Server
Setting Up Propagation
Chapter 9 261
NOTE The <admin/principal> is the same as the one added on the primary
security server in step 2.
Step 5. Start the admin daemon on the secondary security server by using the
following command:
# /opt/krb5/sbin/kadmind
Step 6. Start the propagation daemon on the primary security server, and verify
whether the daemons have started or not, by using the following
command:
# /opt/krb5/sbin/kpropd
Propagation System Started.
[fqdn] subscriber_ip_addrs: <nnn.nnn.nnn.nnn>
[fqdn] Established secure connection for
propagation
[fqdn] no cache file or OK file found; will do
full dump
[fqdn] starting full dump
[fqdn] full_dump successful.
where:
fqdn Specifies the FQDN of the secondary security server.
nnn.nnn.nnn.nnn Specifies the IP address of the secondary security
server.
If the primary security server propagates to multiple secondary security
servers, the message sequence is displayed for each secondary security
server.
Step 7. Start the kdcd and the propagation daemon on the secondary security
server, and verify whether the daemons have started, by using the
following commands:
# /opt/krb5/sbin/kdcd
# /opt/krb5/sbin/kpropd