Filter
Top Products
Migrating to a Newer Version of the Kerberos Server
Migrating from Kerberos Server Version 2.0 to Version 3.0
Chapter 348
# kdb_dump -f /opt/krb5/dumpfilev2.0
Step 2. Copy the dump file to the system on which you are installing the v3.0
Kerberos server
Step 3. Install the v3.0 Kerberos daemons on the new system.
Step 4. Configure the Kerberos server v3.0.
NOTE Ensure that the following values are the same on both the versions of the
Kerberos server:
• Realm name
• Master key name
Ensure that the master key password is identical to the one that was
used in v2.0:
# krbsetup
The instance-based policy applies if you do not subscribe principals to a
specific policy.
You can configure the Kerberos server manually or by using the
krbsetup tool. This is an interactive tool that prompts you for the
required parameters. For more information, type man 1M krbsetup at
the HP-UX prompt or see “Auto-Configuration of the Kerberos Server” on
page 63.
Step 5. Load the dump file generated in step 1 using the following command:
#kdb_load -f
<dump_filename>
On successful completion, the following message is displayed:
Load Successful
Now, the migration process of the principal information is completed.