Filter
Top Products
Installing the Kerberos Server v3.1
Installing the Server
Chapter 2 39
Installing the Server
To install the Kerberos server, complete the following steps:
Step 1. Insert the software media (tape or disk) in the appropriate drive.
Step 2. Type the swinstall command at the HP-UX prompt.
For more information on the swinstall command, type man 1M
swinstall at the HP-UX prompt.
Step 3. In the Specify Source window, select the appropriate path of the depot
and click OK.
Step 4. Highlight T1417AA in the Software Selection dialog box, and select
Mark For Install from the Actions menu to install all filesets in the
bundle.
Step 5. When you have marked the product components you want to install,
select Install (analysis) from the Actions menu.
Step 6. When you have successfully completed the analysis, click OK in the
Analysis dialog to load the Kerberos server filesets.
The swinstall utility loads the filesets. The estimated time for
processing is 5 minutes.
If the installation is not successful, an error message is displayed. The
cause of the failure will appear at the end of the
/var/adm/sw/swagent.log file.
For more information, see Managing HP-UX Software with SD-UX at
http://www.docs.hp.com.
Kerberos server v3.1 is ready for use.
To configure the server to act as either the primary security server or one
of the secondary security servers, see Chapter 7, “Configuring the
Primary and Secondary Security Server,” on page 95 for more
information.