Filter
Top Products
e1200-320 4Gb Fibre Channel Interface Card user and service guide 109
C Inband SCSI-3 commands
The HP e1200-320 4Gb Interface Card supports a set of SCSI-3 commands that can be received inband
over iSCSI/NDMP. When received by the interface card, these commands are then executed by the
interface card itself.
When using SCSI-3 commands to access general management features, the commands can be sent to
device LUNs that are mapped through the interface card.
The following is a list of the SCSI-3 commands that are supported by the interface card. Complete
definitions of SCSI-3 commands can be found in the SCSI-3 standard available from the American
National Standards Institute (ANSI).
General Commands
• REPORT LUNS
• INQUIRY
General commands
Following is a description of a general-use SCSI-3 command. For more information about the other
general-use commands, please contact your service representative.
Report LUNs command
The interface card supports the Report LUNs command. The Report LUNs command will return a list of
Logical Unit Numbers (LUNs) that can receive commands. The format of the report LUNs command is
shown in Table 12.
Table 12 Format of Report LUNs command
Bit
Byte
76543210
0Operation Code ( 0xA0)
1Reserved
2Reserved
3Reserved
4Reserved
5Reserved
6(MSB)
Allocation Length
(LSB)
7
8
9
10 Reserved
11 Control Byte