Filter
Top Products
118 Enabling DHCP on the HP e1200-320 4Gb FC Interface Card
Setting up DHCP over interface card interfaces
Interface cards use three different interfaces which can be used to enable DHCP: Serial, Telnet, and VM.
The following will describe how to enable and disable DHCP for each interface.
NOTE: Located on the interface card is a label that displays the unit’s Ethernet MAC Address. A network
administrator can then use this MAC Address to set up a lease reservation on the DHCP server for the IP
address of the interface card. This effectively allows the interface card to have a permanent IP address
that is assigned by the DHCP server.
Serial and Telnet interfaces
When the user turns on the library, and thus the interface card, the system reboots and displays the
following Main menu on the terminal window:
Figure 80 Main menu
• Select 1. The following menu appears:
Figure 81 Configuration menu
HP StorageWorks e1200-320 4Gb Interface interface card
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
07/7/2005 08:56:22
1) Perform Configuration
2) System Utilities
3) Display Trace and Assertion History
4) Reboot
5) Download a New Revision of The Firmware
Copyright (C) 1998 - 2004 Crossroads Systems, Inc. All rights reserved.
Command >
Configuration Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
07/7/2005 08:56:22
1) Baud Rate Configuration
2) Ethernet Configuration
3) Fibre Channel Configuration
4) Parallel SCSI Configuration
5) Device Mapping
6) Trace and Event Settings Configuration
7) Real-Time Clock Configuration
8) Active Fabric Configuration
A) Save Configuration
B) Restore Last Saved Configuration
C) Reset to Factory Defaults
X) Return to main menu