Filter
Top Products
3
Printing Basics
1
OUT Tray
The printer sends finished pages to the OUT tray.
OUT Tray Flap Down – This is the typical position for most types of printing. The
down position also allows single envelope printing and printing on media smaller
than 100 x 148 mm or 4 x 5 5/8 inches. For information about printing on other
media, see Chapter 2.
Out Tray Flap Up – The OUT Tray Flap must be in the up position to properly load
banner paper. The OUT Tray Flap must remain in the up position to print banners.
Printer Maintenance Tips
Because the printer ejects ink onto the paper in a fine mist, ink smudges will
eventually appear on the printer case. To remove smudges, stains, and/or dried
ink from the exterior of the printer, use a soft cloth moistened with water.
When cleaning your printer, keep these tips in mind:
•
Do not
clean the interior of the printer. Keep all fluids away from the interior.
•
Do not
use household cleaners or detergent. In the event that a household
cleaner or detergent is used on the printer, wipe the printer’s exterior surfaces
with a soft cloth moistened with water.
•
Do not
lubricate the print cartridge support rod. Noise is normal when the print
cartridge cradles slide back and forth.
For information on cleaning print cartridges and the print cartridge cradle,
see page 30.
Single envelope and
small media slot
OUT Tray Flap down
OUT Tray Flap up
Paper width guide