Filter
Top Products
2-10 Removal and Replacement HP OmniBook 900
Removing the LCD Module
(HP Authorized Service Providers Only)
Exchange Information
When returning a bad LCD module to HP, describe the symptoms on a piece of paper and attach
it to the part—do not use tape.
Table 2-7. Display Component Compatibility
LCD Type* 12" IBM 12" Mitsubishi 13" LG 13" Unipac
OmniBook Model 900†/900B 900†/900B 900B 900B
Bezel, display
F1711-60915 F1770-60906
Cable, LCD flex
F1711-60918 F1769-60913 F1770-60923 F1770-60910
Cable, power
F1711-60919 F1770-60912
Case, display
F1711-60978 F1711-60971 F1770-60907
Latch, display
F1711-60979 F1770-60901
Hinge, cover
F1770-60902
Hinge, display (pair)
F1711-60938 F1770-60908
LCD Module
F1711-69039 F1711-69072 F1770-69021 F1770-69020
Support, left hinge
F1711-60910 F1770-60914
Support, right hinge
F1711-60911 F1770-60915
* To identify the type of LCD module, see the marking printed on the LCD flex cable where it plugs into the
base—it may be on the top or bottom of the cable.
† Models called 900† in this manual have no marking in the serial number, whereas models called 900B
have 900 B after the serial number.
Required Equipment
• Small Phillips screwdriver.
• Small flat-blade screwdriver.
• Pointed knife or probe.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. On the display bezel, remove the two upper bumpers and two lower screw covers (using a pointed
knife or probe), then remove the four screws.
3. Along the top of the display, pull the bezel upward, toward the edge of the case, until the snaps
release.
4. Starting at the top corners, repeat along the left and right sides, pulling outward to release the left
and right edges.
5. Lift the top of the bezel away from the case about 7 cm (3 inches). The snaps along the bottom of
the bezel should release.
6. On the edge of the LCD module, unplug the LCD power wires from the power cable.