Filter
Top Products
Solution: Leave the sheet in the output tray until the message disappears. If it is
necessary to remove the printed sheet before the message disappears, carefully hold
the printed sheet on the underside or the edges, and place it on a flat surface to dry.
Out of paper
Cause: There is not enough paper in the input tray.
Solution: If the HP All-in-One is out of paper or there are only a few sheets
remaining, load more paper in the input tray. If there is paper in the input tray, remove
the paper, tap the stack of paper against a flat surface, and reload the paper into the
input tray. Follow the prompts on the display or the computer screen to continue your
print job.
For more information, see:
“
Load full-size paper” on page 65
Cause: The rear door is off the HP All-in-One.
Solution: If you removed the rear door to clear a paper jam, replace it.
For more information, see:
“
Clear paper jams” on page 147
Paper jam, misfeed or blocked print head assembly
Cause: Paper has jammed the HP All-in-One.
Solution: Clear the jam. Touch OK to continue your print job.
For more information, see:
“
Clear paper jams” on page 147
Cause: The print head assembly is blocked.
Solution: Turn off the HP All-in-One and open the ink cartridge door to access the
print head assembly area. Remove any objects that are blocking the print head,
including any packing materials. Turn the HP All-in-One on again.
Paper mismatch
Cause: The print setting for the print job does not match the paper type or size
loaded in the HP All-in-One.
Solution: Change the print setting or load the appropriate paper in the input tray.
For more information, see:
“
Change the print settings for the current job” on page 76
“
Information on paper” on page 147
Chapter 14
200 Troubleshooting
Troubleshooting