Filter
Top Products
Chapter 13 Alternative Rack Mounting
148
Preparing the Rack
The column adapters and the slide mechanism must be connected to the rack
before installing the HP NetServer LC 2000r into the rack. A cardboard
rack-mounting template comes with the HP NetServer. This template shows you
where to mount the column adapters and slides on the rack.
HP NetServer Rack Mount Parts List
Ensure the rack-mounting kit provided with the HP NetServer contains the
following parts:
Table 13-1. Parts for Rack Mount Kit
Quantity Description
2 Slides
4 Rack Nuts
12 Rack Nut Screws (M5 x 16mm)
6 Screws for Slides (8-32 x ¼ inch, 2 flathead, 4 panhead)
2 Column Adapters
1 Template
Mounting Column Adapters
Use this section to connect the two column adapters to the HP Systems rack,
which are required for the Universal Bezel. The rack template and marking pen
are used to identify and mark the locations for the column adapters. The column
adapters attach to the front columns using the captive screws on the column
adapters and don't require any rack nuts.
CAUTION If other rack components are to be mounted in the rack below
the HP NetServer, install those components before starting to
mount the NetServer.
NOTE Use the HP Rack Configuration Tools to determine where in
the rack to mount the HP NetServer.