Filter
Top Products
Chapter 3 Opening and Closing the HP NetServer
23
3. Press the power switch on the HP NetServer’s control panel when
prompted by the operating system.
Normally, this completes the power down procedure.
4. Disconnect the power cord or cords from the power source.
NOTE The power supplies will continue to provide standby current to
the NetServer until the power cable is disconnected.
5. At the front of the HP NetServer, extend the anti-tip foot from under the
front of the rack.
See Chapter 8, "Rack-Mounting the HP NetServer," later in this manual.
Leveler
Foot (4)
Anti-Tip
Foot Extended
Figure 3-1. Extend the Rack’s Anti-Tip Foot
WARNING This anti-tip device must be extended to prevent the rack and
HP NetServer from tipping over, which could damage the
NetServer and injure people.