Filter
Top Products
61
6 Installing Additional Boards
Introduction
This chapter describes how to install accessory boards into the system board of the
HP NetServer LC 2000/2000r. The system board provides up to six PCI slots
(P1 through P6), two of which are 64-bit slots.
Tested PCI Boards
For a list of tested PCI boards, check for compatibility in Configuration Assistant
on the Navigator CD-ROM or look for the Hardware Tested Products list for the
HP NetServer LC 2000/2000r under the Service and Support topic for the specific
NOS used in the NetServer at HP’s web site:
http://www.hp.com/netserver/support/compatibility
CAUTION Some accessory board outputs may exceed U.S. National
Electrical code (NFPA 70) Class 2 or limited power source
limits and must use appropriate interconnecting cabling in
accordance with the National Electrical Code. (All
Hewlett-Packard boards comply with Class 2.)
Tools Required
The following tools are required for installation or removal of the accessories
boards in the HP NetServer LC 2000/2000r:
• An anti-static service kit (3M™ 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap with ground lead.
Remote Control Card
The HP NetServer LC 2000/2000r may use the HP TopTools Remote Control card
in any PCI slot on the system board. The Remote Control card supports HP
TopTools software. An I
2
C connector is provided on the system board. For more
information on use of the HP TopTools Remote Control function, see Chapter 11,
"Information Assistant," and Chapter 10, "Configuring the HP NetServer."