Filter
Top Products
Chapter 6 Installing Additional Boards
67
8. Remove the slot cover from the NetServer’s rear panel, before installing
the new board into the slot, as shown in Figure 6-3.
1. Open Tab
2. Lift Latch
3. Remove Slot Cover
Figure 6-3. Removing the Slot Cover
NOTE Each PCI slot must have a slot cover or PCI board in the slot.
Ensure all unused slots have slot covers in place.
CAUTION Do not bend the PCI board to install it into the slot. If a
full-length PCI board has a handle on the end of the board that
prevents its installation, remove the handle before installing
the board.