Filter
Top Products
Chapter 6 Installing Additional Boards
65
Shaded rectangle
represents the
position of slide
switch.
2 Processor Speed (Bit 1)
3 Processor Speed (Bit 2)
4 Processor Speed (Bit 3)
5 Clear Configuration
6 Clear Password
8 FSB Speed (133/100 MHz)
Open = Off
Closed = On
Rear of HP NetServer
Figure 6-2. Configuration Switch Block
Installing Accessory Boards
Use this procedure to install all accessory boards.
1. Read the documentation included with each board and follow any special
instructions provided.
CAUTION To prevent a system crash, never remove or insert a PCI board
from or into a slot with the NetServer powered on. Always
turn power off to the NetServer before performing any
installation or removal operations.
2. Log off all users and back-up all files.
3. Follow the instructions in the respective NOS (network operating system)
documentation to gracefully shut down all networking software and
applications.
4. Press the power button on the HP NetServer’s control panel when
prompted by the operating system.
Normally, this completes the shutdown procedure.
NOTE The power supplies will continue to provide standby current to
the NetServer until the power cable is disconnected.