Filter
Top Products
Chapter 8 Rack-Mounting the HP NetServer
88
Slide Members
Anti-tip Foot
Leveler
Screws (4)
Mounting Tabs
Figure 8-7. Pulling Out the Slides
3. Pull out both slides until the slide members are fully extended.
See Figure 8-7.
The slides click into position when locked. This locked position prevents
the slides from moving back into the rack, unless the release latches are
pressed as shown in Figure 8-10.
4. With the help of at least one other person, lift the HP NetServer by its four
handles off the floor or pallet.
5. Move the rear of the NetServer just beyond the extended slide members.
6. Position the NetServer’s channels on each side to insert the slide members
into the channels. See Figure 8-8.
The mounting tabs in the slides will engage the slots in the chassis.
See Figure 8-7.