Filter
Top Products
Chapter 4 Installing Mass Storage Devices
51
Installing Non-Hot Swap Storage Devices
Use this section to install any of the non-hot swap mass storage devices used as a
hard drive or a tape backup storage.
CAUTION Protect the drive from static electricity by leaving it in its
anti-static bag until you are ready to install it. Before handling
the drive, touch any unpainted metal surface to discharge
static electricity. When you remove the drive from the
anti-static bag, handle it only by the frame.
Do not touch the electrical components. Place the drive on the
anti-static bag whenever you set it down.
Non-Hot Swap
Drives
(Optional)
Figure 4-13. Non-Hot Swap Drive Shelves
To install a drive in the non-hot swap drive bay, refer to the following procedure.
1. If necessary, shutdown the HP NetServer’s NOS.
Refer to Chapter 2, "Controls, Ports, and Indicators."
2. Disconnect all telephone cables and power cords.