Filter
Top Products
HP OmniBook XE2 Troubleshooting and Diagnostics 3-13
Note that the serial and parallel port tests are more thorough if you connect a loop-back connector to
the port before running the test for that port. See the wiring diagrams below.
14
1
25
1
3
6
1
9
5
Figure 3-3. Serial and Parallel Loopback Connectors
Interpreting the Results
• The following table lists test groups, error codes, and suggestions for follow-up actions. Consider
these suggestions in combination with other troubleshooting information.
Table 3-3. OmniBook Diagnostic Error Codes
Code Suggestions
System Tests
0001h -
0008h
Reseat or replace the CPU module.
0009h Replace the motherboard.
0010h -
002Fh
Reseat or replace the CPU module.
0030h -
0040h
Replace the motherboard.
0041h Unrecognized interrupts. Run BIOS Setup and
check IRQ assignments for all devices.
0050h -
0070h
Replace the motherboard.
0071h Bad CMOS checksum. Reset the system, then
run BIOS Setup and check settings. Replace
motherboard.
0072h Configuration mismatch in CMOS. Reset the
system, then run BIOS Setup and check
settings. Replace motherboard.
0073h Bad CMOS RAM size. Reset the system, then
run BIOS Setup and check settings. Replace
motherboard.
0074h Bad CMOS time. Reset the system, then run
BIOS Setup and check settings. Replace
motherboard.
0075h -
0076h
Reset the system. Replace the motherboard.
0077h Replace the motherboard.
0078h Bad CMOS checksum. Reset the system, then
run BIOS Setup and check settings. Replace
motherboard.
0079h Replace the motherboard.
0083h -
0086h
Replace the BIOS IC. Replace the
motherboard.
0087h Replace the motherboard.
0088h Replace the BIOS IC.
0090h -
0096h
Replace the BIOS IC. Replace the
motherboard.
009Ah -
009Eh
Replace the BIOS IC. Replace the
motherboard.
009Fh Insufficient DOS memory. Load fewer device
drivers.
00A0h No repair. (ESCD not supported.)
00A1h Replace the BIOS IC. Replace the
motherboard.
00A2h -
00A3h
No repair. (ESCD not supported.)
00A4h Replace the BIOS IC.
00A5h -
00A6h
No repair. (ESCD not supported.)
00A7h Replace the BIOS IC. Replace the
motherboard.
00C0h -
00CCh
Replace the CPU module.
00FFh Rerun the test. (Possible diagnostic
programming error.)
Memory Tests
The addresses below are absolute (32-bit) address. These
addresses are not in the segment:offset format.
0100h -
0101h
Replace the motherboard.
0102h Replace the BIOS IC.
0120h -
0150h
For the OB 4100 for 01FFFFFFh and below,
replace the motherboard. Otherwise, replace
the RAM board (each 01000000h represents
16MB).
0160h Address bus short. Remove any RAM board
and rerun the test. Check the CPU module for
shorts. Replace the motherboard.
0170h -
0172h
Replace the motherboard.
These connections
are not used.
Diodes are 1N4004 or equivalent
(I
F
=1A, V
F
=1V@1A, V
R
=30-400V)