Filter
Top Products
Chapter 1: Controls, Ports, and Indicators
5
SCSI Hard Drives
The server supports up to two hot-swap drive carriers containing standard 1-inch high by 3.5-inch-
wide LVDS SCSI hard drives. As part of the hot-swap implementation, drive carriers with integral
heat sinks house the drives. Each drive is mounted in a carrier with four fasteners and the carrier
snaps into the hard drive bay. When a carrier is seated properly in the bay, it snaps into place and
leaves the locking handle exposed to the front of the chassis. Drives can consume up to 24 watts of
power and must be specified to run at a maximum ambient temperature of 40 ° C (104 ° F).
LCD DISPLAY
POWER
PWR PWR ACTIVEACTIVE FAIL FAIL
RESET INT SYS PWR PWR FAN GEN
LCD DISPLAY
POWER
PWR PWR ACTIVEACTIVE FAIL FAIL
RESET INT SYS PWR PWR FAN GEN
Power LED
Drive Active
Failure LED
Power LED
Drive Active
Failure LED
Figure 1-4. SCSI Drive Indicators on the Front LED Panel
Table 1-4. SCSI Drives
Control Indicator Description
Drive Power LED
(Green)
When lit continuously, it indicates the presence of
the drive and power to the drive.
Drive Active LED
(Green)
When lit, it indicates drive activity.
Drive Fail LED
(Amber)
When lit continuously, it indicates an asserted fault
status on one or more hard disk drives. When
flashing, it indicates a drive reset in progress.