Filter
Top Products
12
2 Opening and Closing the HP Server
Introduction
This chapter describes how to remove and replace the front bezel and the HP Server's main cover.
Mounting the Front Bezel
The front handles, if not already installed on the HP Server, should be attached to the front of the HP
Server before mounting the bezel.
1. Place the handles into the slots on the front of the HP Server on each edge, as shown in the
figure below.
2. Insert the screws through the bracket into the top hole of each group of three holes on the front
sides of the HP Server. Repeat this procedure for both handles.
3. Hold the bezel in front of the HP Server.
4. Press the bezel firmly into place.
You should hear several clicks as the bezel snaps into place on the bracket.
Removing and Replacing the Front Bezel
The bezel is packed in the top tray.
1. To remove the bezel, pull it straightforward off the chassis.
This exposes the power supplies, mass storage devices, and fans.
2. To replace the bezel, press it back onto the chassis, allowing it to snap into place. See Figure
2-1.