Filter
Top Products
NEC CONFIDENTIAL 4-93
Select test start/end block sub-menu
Specify the transfer block size of the SCSI device to be tested.
The following sub-menus are displayed when “Sequential access” is selected from the “Select Test Seek
Mode” menu shown in Figure 4.1.
(SBN) Enter start block [Hex][0 – 1fe887]
00000000
Up/Down-Cursor: Change Values
ESC:Cancel
Figure 4.1 Select test start block sub-menu
(EBN) Enter end block [Hex][0 - 1fe887]
1fe887
Up/Down-Cursor: Change Values
ESC:Cancel
Figure 4.2 Select test end block sub-menu
• If out-of-range values or illegal data such as characters are input, correct date must be input
again.
• The maximum block number is different in every device and medium.
Select Test Transfer Block Size menu
Select the transfer block size of the SCSI device to be tested. This menu is displayed only when “Transfer
Block Size” is selected from the menu shown in Figure 4.1.
(BLOC) Select Test Transfer block Size
(RAN) Random Block size
(SPC) Specified Block size
Figure 4.1 Select Test Transfer block size menu