Filter
Top Products
Stand
The stand is secured with three Torx screws. You must remove the center access panel to remove
the stand.
To remove the stand:
1. Prepare the computer for disassembly (see
Preparing to Disassemble the Computer
on page 29).
2. Remove the center access panel (see
Center Access Panel on page 32).
3. Remove the three silver Torx screws (1) that secure the stand to the computer.
4. Rotate the stand upward (2), and then lift the stand off the computer (3).
Figure 6-5 Removing the stand
To replace the stand, reverse the removal procedures.
Stand 33