Filter
Top Products
Processor
1. Prepare the computer for disassembly (see Preparing to Disassemble the Computer
on page 29).
2. Remove the center access panel (see
Center Access Panel on page 32).
3. Remove the memory access panel (see
Memory Access Panel on page 34).
4. Remove the drive access panel (see
Drive Access Panel on page 35).
5. Remove the stand (see
Stand on page 33).
6. Remove the optical drive (see
Optical Drive on page 37).
7. Remove the top panel (see
Top Panel on page 45).
8. Remove the rear cover (see
Rear Cover on page 48).
9. Remove the system board cover (see
System Board Cover on page 49).
10. Remove the heat sink (see
Heat Sink (Thermal Module) on page 59).
11. Rotate the locking lever to its full open position (1).
12. Raise and rotate the microprocessor retainer to its fully open position (2).
13. Carefully lift the processor from the socket (3).
CAUTION: Do NOT handle the pins in the processor socket. These pins are very fragile and
handling them could cause irreparable damage. Once pins are damaged it may be necessary to
replace the system board.
The heat sink must be installed within 24 hours of installing the processor to prevent damage to
the processor’s solder connections.
Figure 6-44 Removing the processor
Processor 61