Filter
Top Products
Chapter 4 117
Field Replaceable Units
FRU Removal and Replacement
3. Load the DIMM cards in the memory slots using the loading sequence provided in
Figure 4-43. Note that the B2000 system label located on the chassis floor also explains
the loading sequence for DIMM cards. See Figure 4-44. Follow the steps in Figure 4-45
to install each DIMM card.
NOTE
When installing memory, you need to orient the notches on the bottom
edge of the DIMM card so that they are aligned with the keys on the DIMM
connector. See Figure 4-45. The keyed DIMM connectors prevent you from
installing the DIMM cards backwards.
Figure 4-44. B2000 System Label
Figure 4-45. Installing a DIMM Card
Front of the
Workstation
Memory Loading Sequence on
B2000 System Label
Notches
Ejector Tab
Ejector Tab
Press down on the ejector tabs
to open them and place the
DIMM card in the connector
with your fingers on the edge
of the DIMM card. Be sure the
Push the DIMM card down
firmly and evenly into the
connector to be sure it is
properly seated.
Step 2
Step 1
notches on the bottom edge of the
DIMM card aligns with the keys
on the DIMM connector.