Filter
Top Products
Chapter 4 83
Field Replaceable Units
Chapter Overview
Tools Required
Use the following tools to remove or replace FRUs in the B2000 workstation:
• Torx T-15 driver
• Light-duty flat blade screw driver with 6-inch (150 mm) blade
• Needle-nose pliers
• ESD equipment (see “Electrostatic Discharge (ESD) Precautions” on page 177)
Exploded View Diagram
Figure 4-1 shows an exploded view of the FRUs in the B2000 workstation. Refer to this
figure for the locations of the various workstation FRUs while performing the FRU
removal and replacement procedures in this chapter.
Figure 4-1. Exploded View Diagram of the B2000 Workstation FRUs
Front Panel
System Board
Tray Assembly
Left Side
Panel
Power
Supply
CD Drive
Bracket
Floppy Disk
Drive Bracket
Chassis
Air Divider
DIMM
Hard Disk Drive
and Bracket
Voltage
System Fan
I/O Fan
Speaker
Battery
Cards
Modules
Regulator
PCI
Retainer
Clip
in Bracket
(Master
and Slave)