Filter
Top Products
117
6. Troubleshooting
6. Troubleshooting
(continued on next page)
*
User’s Manual (detailed) - Operating Guide
Problem Likely Cause Things to Check
Reference
Page
Number
No image
The projector is not turned
on.
Is the projector’s lamp on?
*16
The projector’s input source
isn’t switched to MIU.
Is the projector switched to
MIU?
*17, 18
Wireless / Wired
Live Mode
The projector
that you want
to connect to
is nowhere
to be found
on the list
of available
projectors
The PC and/or projector’s
network settings are not
configured correctly.
Check both the PC and
projector’s network settings.
If you change the projector’s
settings, turn off the
projector’s AC power and
then turn it on again. If you
simply put the projector in
STANDBY power mode and
then turn it on again, the new
settings might not take effect.
10
Weak radio signal
• Bring the PC and projector
closer together.
• Radio waves won’t go
through concrete and
metal (steel doors, etc.)
–
Can't
communicate
The Projector isn’t in Live
Mode
Check the mode on MIU
menu to make sure that it is
in the correct mode.
*55
WPA-PSK or/and WPA2-
PSK is not configure
correctly in Windows 2000
or Windows XP/XP SP1/XP
SP1a.
In Windows 2000 and Windows
XP/XP SP1/XP SP1a,WPA-PSK
and WPA2-PSK could not configure
via LiveViewer 3. Use wireless
configuration utility with PC or
wireless adapter. Please refer
the manual of your configuration
utility. If you are using Windows
XP/XP SP1/XP SP1a, you can
configure WPA-PSK and WPA2-
PSK by updating to SP2 or later.
–
Cannot communicate due
to configure wireless /
encryption settings
If there is a wireless
configuration utility loaded
on your PC, check the
configuration settings of it.
Please refer the manual of
your configuration utility.
–
Configuration network
settings of LiveViewer may
not be set correctly.
Be sure that the
configuration settings of
LiveViewer are correct
for usage with your PC or
wireless adapter.
10