Filter
Top Products
16
2. Equipment connection and network setting
2.4 Manual network connection setting –Wireless LAN
The projector and PC can communicate in both of Ad-Hoc and Infrastructure
modes, using the designated wireless network card (option) on the projector.
This section is intended to explain how to set up wireless LAN connection
manually.
2.4.1 Preparation for wireless LAN connection
First, insert the wireless network card into SD card slot (
Using an SD card of
the User’s Manual (concise) ).
Then, make PC ready for wireless communication.
In case IEEE802.11b/g wireless LAN device is built-in the PC, make it valid and
make other network connections invalid. If wireless LAN device is not built-in the
PC, connect IEEE802.11b/g wireless LAN device and install device driver. (Refer
to the user guide for PC and wireless LAN device for detail.)
* Ad-Hoc is one of the wireless LAN communication methods without having
access point to communicate.
* Infrastructure is one of the wireless LAN communication methods with having
access point to communicate. If certain quantities of equipments are used, this
mode is efcient.
If communicating with existing network, contact your network administrator.
Fig. 2.4.1.a Without an access point communication (Ad-Hoc)
Fig. 2.4.1.b With an access point communication (Infrastructure)
SD CARD
SD CARD