Hi-Touch Imaging Technologies CS-320 Printer User Manual


 
www.hi-ti.com
39
Ribbon out The ribbon has been used up.
1. Please install a new ribbon.
2. Please follow the instructions from the LCD display to
switch the ribbon sensors (Please refer to Chapter 3,
section 2, the description of RIBBON 1)
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website: http://www.hi-ti.com
Ribbon missing
The card printer does not detect the
ribbon.
1. Please make sure the ribbon is present.
2. Please make sure the ribbon has been installed
properly.
3. Please clean the chip on the side of the ribbon and
re-install the ribbon to the card printer.
4. Please close the ribbon door properly.
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website: http://www.hi-ti.com
Door open
The ribbon is not installed or the ribbon
is installed in an improper position or
the ribbon door is in the correct
position.
1. Please check if the ribbon is present.
2. Please make sure the ribbon has been properly
installed, remove and re-install the ribbon if necessary.
3. Please close the ribbon door to the proper position.
Ribbon IC R/W
error
An error occurs in the chip.
1. Please remove the ribbon.
2. Please clean the chip in the side of the ribbon and
re-install the ribbon.
3. If the error message still exists, please install a new
ribbon.
4. If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website: http://www.hi-ti.com
Unsupported ribbon Wrong ribbon for this printer. Please install the correct ribbon.
Unknown ribbon The ribbon can not be recognized. Please install the correct ribbon.