Filter
Top Products
www.hi-ti.com
41
Cam TPH error
Cam pinch error
Cam flipper error
Cam Mag error
The error occurs in the mechanism.
Check sum error -
SDRAM
Check sum error –
SRAM
Check sum error –
FLASH
Check sum error –
Wrong firmware
The version of the firmware is not
correct.
Press the ‘Cancel” button to restart the card printer. Or
download the latest version of firmware from HiTi
website and follow the instructions from the HiTi Card
Printer User Manual to re-install the firmware.
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website: http://www.hi-ti.com
Nvram R/W error
Nvram CRC error
The error occurs due to memory inside
the card printer.
Please restart the card printer. If the error message still
occurs, please contact your nearest HiTi distributor or
HiTi customer service center.
Website: http://www.hi-ti.com
Command sequence
error
The error occurs due to command
sequence.
Please restart the card printer or download the latest
Firmware from HiTi website and follow the instruction
from HiTi Card Printer User Manual to re-install the
firmware.
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website: http://www.hi-ti.com
USB connection
was broken
Your PC adopts USB 1.1 Host
Controller, and uses other USB devices
(Including other HiTi printers) at the
same time.
1. Please do not use any other USB devices at the same
time to avoid USB compatibility problems if your PC
is using a USB 1.1 Host Controller.
2. To avoid any kind of USB compatibility problem,
please upgrade your PC to USB 2.0 Host Controller.
Notice:
You can check version of the Host Controller via
"Control Panel/ System/ Hardware/ Device Manager/
USB Universal Host Controller". It is USB 2.0 Host
Controller if you see "xxx xxxx Enhanced Host
Controller xxxx".
Trying to re-connect
to the device, please
wait a moment
Some USB devices and HiTi printer
plug into the same USB 1.1 host
controller, and both work at the same
time, there might be some kind of USB
conflict and this may interrupt the
printing job.
1. You can either upgrade your computer to USB 2.0 or
stop operating the other USB device while the HiTi
printer is printing.
2. You can try to switch the other USB device into a
different USB port and use the program,
CheckUsb.exe, to check if there is any conflict in the
USB connection. (For CheckUsb.exe, please contact
HiTi customer service center.)