Filter
Top Products
www.hi-ti.com
7
1-2 Appearance of CS-310/320
z CS-310/320 Front side*
A. Card Input Hopper
This is the Card Input Hopper for storing blank cards. Please insert the blank cards gently and
remember to shield them with the built-in cover to avoid any dust entering in there.
B. Card thickness selection button
HiTi CS-310/320 provides four selections for thickness: 0.3 mm (10 mil), 0.5 mm (20 mil), 0.8 mm
(30 mil) and 1.0 mm (40 mil). Please move and slide the selector for thickness to the correct
thickness position, which matches the thickness of the cards in the Card Input Hopper.
Remark: The Thickness tolerance of cards are 03mm +/-0.02mm (0.28 ~ 0.32mm), 0.5mm +/-0.03mm
(0.47 ~ 0.53mm), 0.8mm +/-0.04mm (0.76 ~ 0.84mm), 1.0mm +/-0.05mm (0.95 ~ 1.05mm). If your card
thickness is out of the above specification, it may cause significant damage to HiTi ribbon; may
reduce the life span of HiTi Card Printer; may damage print head; and may cause unsatisfactory
color performance.
C. LCD Display:
The status of the printer is displayed on the LCD screen, you can use [◄], [►], [OK], [ESC]
buttons to control the operation of the printer and for troubleshooting.
D. ID Button
To replace ribbon cartridges, please gently slide the ID button on the top of the printer to open the
ribbon door.
E. Rejected box
When an error occurs during the reading/writing process for smart chips and/or magnetic cards,
these cards are ejected into a rejected box, which holds about 20 cards. The system will show an
error message when cards accumulate to around 20 pieces in the rejected box. Please remove
these cards to continue the printing task.
F. Card Output Hopper
The printed cards will be placed here.
*For CS310i / CS320i (Card Printer + Laminator), the front view is shown as follows.
Laminator
Card Printer