Filter
Top Products
10 - 3
We recommend use of Honeywell peripherals, power cables, and power adapters that comply with L.P.S. Use
of any non-Honeywell peripherals, cables, or power adapters may cause damage not covered by the warranty.
Connecting Power to the ChargeBase
1. Plug the A/C power cord into the power adapter.
2. Plug the power connector cable into the power connector on the back of the ChargeBase.
3. Plug the A/C power cord into a standard wall outlet.
4. The base is ready to begin charging terminals.
Charging the Battery
The base provides power to the Dolphin terminals and allows the
charging of the batteries in the terminals. The battery of each terminal
charges in 6 hours for the standard 3.7V battery or 9 hours for the
extended 3.7V battery. The intelligent battery charging system incor-
porated into all Dolphin terminals prevents overcharging, which means
that Dolphin terminals may be stored in the base indefinitely without
damage to the terminals, battery packs, or the base.
To Power a Terminal and Charge its Battery
1. Install the battery pack in the terminal; see Install the Main Battery on page 2-1.
2. Verify the base has power. If the LEDs are not illuminated, see Connecting Power to the
ChargeBase on page 10-3.
3. Slide the Dolphin terminal into one of the four terminal wells. The the Power/Dock LED for the well
changes to green. Charging begins immediately if required by the Dolphin terminal.
Make sure the terminal is dry before placing it in the ChargeBase. Do NOT place a wet terminal in the
ChargeBase! Doing so may cause damage not covered by the warranty.
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in dam-
age not covered by the warranty.
!
Power Connector Cable
A/C Power Cord
Power
Adapter
!
!