Filter
Top Products
26
6 FAQs
How can I quickly enable or disable the wireless network function?
Press and hold the WLAN button for over one second, and then release
the button to enable or disable the wireless network function. The WLAN
indicator shows whether the wireless network function is enabled.
How can I quickly restore the default settings of the terminal?
To restore the default settings, press and hold the Reset button on the
rear panel for over six seconds after the HG533 is powered on, and then
release the button.
What can I do if I cannot access the Internet through the terminal?
Step 1 Check whether the Power indicator on the terminal is solid on.
If the Power indicator is off, perform further checks as follows:
1. Ensure that the terminal is turned on.
2. Ensure that electricity comes from the socket and that the
power input from the socket meets the requirements described
on the label of the terminal power adapter. If the voltage is
unsteady, for example, if the voltage is too high or too low, do
not use the terminal. Wait until the voltage restores to its normal
level, and then use the terminal.
3. Ensure that the terminal is properly connected to the socket
through the power adapter.
If the Power indicator is still off, contact an authorized maintenance
center.
Step 2 After powering on the terminal, wait for about three minutes.
Then, check whether the ADSL indicator on the terminal is solid
on.
If the ADSL indicator blinks for a long time, perform further checks as
follows:
1. Ensure that telephone lines are properly connected. Pay
special attention to the connections between the telephone
lines and the splitter.
2. Ensure that the terminal or telephone lines are far from the