Filter
Top Products
Action
Specify source volumes that are all contained within the same logical subsystem,
and then resubmit the command. Issue separate commands for volumes that are
contained within different logical subsystems.
CMUC00130E COMMAND_INFO All target volumes must be within the same
logical subsystem.
Explanation
The -tgtss flag is specified with the command. This flag requires that all target
volumes are contained within the same logical subsystem. Not all of the target
volumes specified are contained within the same logical subsystem.
Action
Specify target volumes that are all contained within the same logical subsystem,
and then resubmit the command. Issue separate commands for volumes that are
contained within different logical subsystems.
CMUC00131E COMMAND_INFO Operation failure
Explanation
The lshostvol command fails for one of the following reasons:
v The CLI installation did not complete successfully.
v A platform-dependent external command is being invoked unsuccessfully.
v You lack sufficient privileges.
Action
Check the CLI installation log for errors and reinstall if necessary. Ensure that you
have the appropriate privileges to perform the task. If the problem persists, contact
IBM technical support for assistance.
CMUC00132E COMMAND_INFO Command interrupted. Resubmit the command.
Explanation
The lshostvol command was interrupted for an unknown reason.
Action
Resubmit the command. If the problem persists, contact IBM technical support for
assistance.
CMUC00133I COMMAND_INFO User USERNAME successfully created.
Explanation
The user has been created successfully.
Chapter 2. DS command-line interface messages 43