IBM EM78P447N Network Card User Manual


 
EM78P447N
8-Bit Microcontroller with OTP ROM
Product Specification (V1.1) 03.30.2005
21
(This specification is subject to change without further notice)
4.5.2 The Status of RST, T, and P of STATUS Register
A RESET condition is initiated by one of the following events:
1. A power-on condition,
2. A high-low-high pulse on /RESET pin, and
3. Watchdog timer time-out.
The values of T and P (listed in Table 8 below) are used to verify the event that
triggered the processor to wake up.
Table 8 shows the events that may affect the status of T and P.
Table 8 The Values of RST, T and P after RESET
Reset Type T P
Power on 1 1
/RESET during Operating mode
*P *P
/RESET wake-up during SLEEP1 mode 1 0
/RESET wake-up during SLEEP2 mode
*P *P
WDT during Operating mode 0
*P
WDT wake-up during SLEEP1 mode 0 0
WDT wake-up during SLEEP2 mode 0
*P
Wake-Up on pin change during SLEEP2 mode
*P *P
*P: Previous status before reset
Table 9 The Events that may Affect the T and P Status
Event T P
Power on 1 1
WDTC instruction 1 1
WDT time-out 0
*P
SLEP instruction 1 0
Wake-Up on pin change during SLEEP2 mode
*P *P
*P: Previous value before reset