Filter
Top Products
v Information about uploading electronic journal data while the printer is emulating
a Model 4 printer has been added. See Appendix E, “Uploading electronic journal
data,” on page 187.
v The following commands have been added:
Note: These commands are not supported for Models TI1 and TI2. Currently
installed Model TI3, TG3, TI4, and TG4 printers support these commands
after you download the latest firmware.
– “Proportional font” on page 120
– “Select color printing” on page 137
– n=09 (Align Column Right) for “Align positions” on page 139
– “Enable or disable upside-down printing” on page 144
– “Select character size for scalable fonts” on page 145
– “Fix font matrix” on page 146
– “Print logo inline” on page 146
– “Select thermal paper” on page 147
– n=09 (Code 128A, 128B, and 128C) for “Print bar code” on page 147
v The following command, which is supported only on Models TF6 and TM6, has
been added:
– “Enable or disable the beeper (Models TF6 and TM6 only)” on page 143
GA27-4151-03
This edition includes information for the support of a USB logic card.
Information that was added includes:
v “USB connector pin assignments” on page 92.
v USB information has been added to “Voltage conversion circuitry” on page 89.
v The part number for the available USB cables has been added to “Features used
with the SureMark printers” on page 6.
v Information about your responsibilities when using USB communications has
been added to “Planning information” on page 9.
v The data rate for USB communications has been added to “Communication
interfaces” on page 10.
v USB information has been added to “Hardware requirements” on page 13.
v Information about installing the SureMark printer for use with USB
communications has been added to “Installing SureMark for USB communication”
on page 21.
v Information about installing fillers for the SureMark printer when the USB feature
is used has been added to “Installing fillers for USB printers” on page 26.
v Communication mode information for USB has been added to “USB
communication mode” on page 31.
v Relevant information for performing problem determination with USB has been
added to Table 3 on page 67.
Updated April 2, 2009
Summary of changes xix