Filter
Top Products
5
II - LED Operation
The following are iMcV-Giga-FiberLinX-II diagnostic LEDs. In this example, the
functions for a 1x9 fiber port version (SC fiber) are shown below.
NOTE
In the SFP/SFP version the LNK/ACT and FDX/COL LEDs replace EXT 1000 and
DATA 1000 for the top SFP, which does not have built-in LEDs like the RJ-45
DATA port. In addition, the copper SFP LNK/ACT LED glows green (does not
flicker).
Port LEDs
FDX/COL
:
•
Glows yellow when port is operating in Full-Duplex.
•
Blinks yellow when collisions occur on port.
LNK/ACT
:
•
Glows green when link is established on port.
•
Blinks green during data activity on port.
Diagnostic LEDs Optics Port LEDs
Optics Port LEDs
•
Glows yellow when port is operating in
Full-Duplex.
•
Blinks yellow when collisions occur on
port.
FA:
Glows green when FiberAlert is enabled.
FTL (Far TX Link):
•
Host
: Glows green when a link is
established on remote (far-end) DATA
port.
•
Remote
: Glows green when unit is
configured as Remote.
•
Standalone
: LED remains OFF.
LNK/ACT (Link/Activity):
•
Glows green when link is established on
port.
•
Blinks green during data activity on port.
FDX/COL (Full Duplex/Collision):
FCU (Far CPU Up):
•
Host:
Glows green when
far end is detected.
•
Remote:
Glows green
for Remote units.
•
Standalone
: LED
remains OFF.
SNMP:
Glows green with SNMP
activity.
EXT 1000:
Glows green when EXT
MGMT
port is operating at 1000
Mbps.
DATA 1000:
Glows yellow when D
A
TA po
r
is operating at 1000 Mbps.