Filter
Top Products
25
USING THE PROJECTOR
This section describes how to use and make adjustments to the
projector. It also provides a reference to the remote control but-
tons and the options available from the on-screen menus.
Basic Image Adjustment
1 Make sure you have powered up your equipment in the right
order (page 21).
2 If the image doesn’t display completely, adjust the height of
the projector (page 26) or center the image by adjusting its
horizontal or vertical position (page 38).
3 If the image is out of focus, rotate the lens to focus it (page 26).
4 If the image appears to shimmer or if it has blurry vertical
bars after you have adjusted the focus, turn Auto Image
(page 37) off and then back on to reset the automatic sync and
tracking. If that doesn’t clear up the image, adjust the sync
(page 37) and/or the tracking (page 38) manually.
5 If the colors don’t look right, adjust the brightness (page 29).
Using the Remote Control
NOTE: If you can’t aim the
remote control at the projector so
that its signal is received
— for
example, when using rear projec-
tion
— connect the remote
directly to the projector with the
remote control cable (page 21).
Point the remote control at the projection screen or at the front or
rear of the projector. The range for optimum operation is about
40 feet. If you point the remote at the projection screen, the dis-
tance to the screen and back to the projector must be less than or
equal to 40 feet. For best results, point the remote directly at the
front or the rear of the projector.