Filter
Top Products
45
Resetting the Lamp Monitor Light
After replacing the lamp, you must reset the lamp monitor light.
NOTE: You must reset the lamp
monitor light so the projector can
keep track of the usable life of the
new lamp.
1 Press and hold the two brightness buttons on the keypad for at
least 5 seconds.
2 Release the buttons. The lamp monitor light goes out after it is
reset.
Replacing the Batteries in the Remote Control
The life of the batteries depends on how often and how long you
use the remote. Symptoms of low battery charge include erratic
responses when using the remote and a reduced range of opera-
tion.
Follow these steps to replace the batteries:
1 Turn the remote face down in your hand.
2 Slide the battery cover off the end of the remote by pressing
on it with the heel of your hand.
3 Remove the old batteries.
4 Install two new AA alkaline batteries. Make sure you install
each in the correct direction.
5 Slide the battery cover back on the remote.
Replacing the Fuse
A power line surge or spike can blow the power supply fuse,
causing the projector to stop working. If this happens, you’ll need
to replace the fuse.
CAUTION: Use only the speci-
fied power supply fuse. Using a dif-
ferent fuse may damage the
projector.
The projector ships with a 6.3 amp fuse. The correct replacement
fuse depends on the power line voltage in the country where you
are operating the projector.
• If your line voltage is 115V to 240V, use a T6.3AH, 250V,
5x20mm fuse.
• If your line voltage is 100V to 115V (as in Japan), use a T8AH,
250V, 5x20mm fuse. You can order the fuse from your In Focus
dealer; the part number is listed on page 58.