Filter
Top Products
Operation26
Entering the password recall procedure
Press and hold AUTO on the projector or
remote control for 3 seconds. The projector
will display a coded number on the screen.
Write down the number and turn off your
projector. Seek help from the local service
center to decode the number. You may be
required to provide proof of purchase
documentation to verify that you are an
authorized user of the projector.
Changing the password
1. Open the OSD menu and go to the SYSTEM SETUP: Advanced> Security
Settings > Change Password menu.
2. Press Mode/Enter. The message 'INPUT CURRENT PASSWORD' displays.
3. Enter the old password.
i. If the password is correct, another message 'INPUT NEW PASSWORD'
displays.
ii. If the password is incorrect, the password error message displays lasting
for three seconds, and the message 'INPUT CURRENT PASSWORD'
displays for your retry. You can press Menu/Exit to cancel the change or
try another password.
4. Enter a new password.
The digits being input will display as asterisks on-screen. Write your selected password down
here in this reference guide in advance or right after the password is entered so that it is
available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this reference guide in a safe place.
5. Confirm the new password by re-entering the new password.
6. You have successfully assigned a new password to the projector. Remember
to enter the new password next time the projector is started.
7. To leave the OSD menu, press Menu/Exit.
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced >
Security Settings > Change Security Settings menu after opening the OSD
menu system. Press Mode/Enter. The message 'INPUT PASSWORD' displays.
Enter the current password.
i. If the password is correct, the OSD menu returns to the Security Settings
page.
Press to highlight Power On Lock and press / to select Off. You
will not have to enter the password next time when turning on the
projector.
Press to highlight Splash Screen Lock and press / to select Off.
The Splash Screen function in the SYSTEM SETUP: Basic menu will be
available for your change.
Please write down the recall code,
and contact InFocus
Customer Center.
Recall Code:
0 2 1 2
RECALL PASSWORD
ExitMENU