Filter
Top Products
Operation42
Shutting down the projector
1. Press Power and a confirmation
message will display prompting you.
If you don't respond in a few seconds, the
message will disappear.
2. Press Power a second time. The
Power indicator light flashes orange, the
projection lamp shuts down, and the fans
will continue to run for approximately 90
seconds to cool down the projector.
CAUTION
• To protect the lamp, the projector will not respond
to any commands during the cooling process.
• To shorten the cooling time, you can also activate
the Quick cooling function. See "Quick Cooling"
on page 48 for details.
3. Once the cooling process finishes, the Power
indicator light is a steady orange and fans
stop. Disconnect the power cord from the wall
socket.
If the projector is not properly shut down, to protect the
lamp, when you attempt to re-start the projector, the fans
will run for a few minutes to cool down. Press Power
again to start the projector after the fans stop and the
Power indicator light turns orange.
I
I
I
I