Filter
Top Products
Operation 27
ii. If the password is incorrect, the password error message displays lasting
for three seconds, and the message 'INPUT PASSWORD' displays for
your retry. You can press Menu/Exit to cancel the change or try another
password.
Though the password function is disabled, you need to keep the old password in hand should
you ever need to re-activate the password function by entering the old password.
Switching input signal
The projector can be connected to multiple devices at the same time. However, it
can only display one full screen at a time. When starting up, the projector
automatically searches for the available signals.
Be sure the Quick Auto Search function in the SOURCE menu is On (which is the
default of this projector) if you want the projector to automatically search for the
signals.
You can also manually cycle through the
available input sources.
1. Press SOURCE on the projector or remote
control. A source selection bar displays.
2. Press / until your desired signal is
selected and press Mode/Enter.
Once detected, the selected source
information will display on the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps 1-2
to search for another signal.
• The brightness level of the projected image will
change accordingly when you switch between
different input signals. Data (graphic) "PC"
presentations using mostly static images are
generally brighter than "Video" using mostly
moving images (movies).
The input signal type effects the options available
for the Picture Mode. See "Selecting a picture
mode" on page 33 for details.
• The native display resolution of this projector is in a
4:3 aspect ratio. For best display picture results,
you should select and use an input source which
outputs at this resolution. Any other resolutions will
be scaled by the projector depending upon the
'aspect ratio' setting, which may cause some image
distortion or loss of picture clarity. See "Selecting
the aspect ratio" on page 32 for details.
• If the frequency/resolution of the input signal
exceeds the projector's operating range, you will
see the message 'Out of Range' displayed on a
blank screen. Please change to an input signal
which is compatible with the projector's resolution
or set the input signal to a lower setting. See
"Timing chart" on page 59 for details.
D-Sub / Comp.
Video
S-Video
DVI-A
DVI-D