Filter
Top Products
11-6
Adding the Initio driver to an existing UnixWare system
1. Once a UnixWare session is established and a command prompt is ready,
type (recall that UnixWare is case sensitive):
• • cp /stand/unix /stand/unix.org , press <ENTER>
• pkgadd -d diskette1 , press <ENTER>
2. Select i910u ihv hba from the list of available host drivers, press
<ENTER>.
3. If the INI-9100U/9100UW is intended to be the bootable host adapter, the
next step to updating the driver will require a revision to the I910u file.
These instructions will guide you through changing the current software
settings for UnixWare to establish the INI-9100U/9100UW as the host
adapter for your boot device:
• At the system command prompt, type
• • cd /etc/conf/sdevice.d
• Use “vi” or another editor to modify the file I910u by adding a
line
• • locate the line $version2
• • edit the file by adding the line $static immediately
following $version2.
• Rebuild the UnixWare kernel by completing the following steps at the
command prompt :
• • /etc/conf/bin/idbuild -B <ENTER>
• • cp /etc/conf/cf.d/unix /stand/unix <ENTER>
• • cd / <ENTER>
• • shutdown -g0 ( 0 is Zero ) <ENTER>
• Y <ENTER>