Filter
Top Products
11-3
• Host adapter interrupt level must be set to IRQ 10 for proper installation of
the Initio driver.
Please refer to your system documentation to set the interrupt levels and your
peripheral documentation for help in setting SCSI IDs.
Installing the Initio driver in a new UnixWare system
Drivers for the Initio host adapter may be found on the INITIO INI-
9100U/9100UW DRIVER DISK 2. In most cases you will load the drivers
during a new installation of UnixWare from CD-ROM. The driver is loaded
during the early stages of the installation procedure. The UnixWare
installation program will prompt you for the required parameters as the
installation procedure progresses. It is highly recommended that you have a
copy of the SCO UnixWare Installation Handbook and SCO UnixWare System
Owner Handbook for reference.
1. Insert the “SCO UNIXWARE INSTALLATION DISKETTE” into the
floppy drive and turn on the computer. A screen similar to the following
will be displayed (see figure 11-1).
figure 11-1UnixWare Installation