Filter
Top Products
4 ETX® connectors
Kontron User's Guide ETX CD 32
IrDA
The ETX®-CD is capable of IrDA SIR operation. This feature is implemented in the Winbond 83627HF.
Contact Kontron Embedded Systems for help with this feature.
Parallel Port
The parallel-communication interface shares signals with the floppy-disk interface. The implementation
of this parallel port complies with the ETX® Specification. Implementation information is provided in the
ETX® Design Guide. Refer to the documentation for additional information.
Configuration:
The parallel-communication interface uses I/O, IRQ, and DMA resources. The resources are allocated by
the BIOS during POST configuration and are set to be compatible with common PC/AT settings. You can
change some parameters of the parallel-communication interface through the BIOS setup.
Floppy
The floppy-disk interface shares signals with the parallel-communication interface. The floppy interface
is limited to one drive (drive_1). A standard floppy cable has two connectors for floppy drives. One
connector has a non-twisted cable leading to it, the other has a twisted cable leading to it. When using
the floppy interface you must connect the floppy drive to the connector (drive_1) that has the non-
twisted cable leading to it.
The implementation of this subsystem complies with the ETX® Specification. Implementation
information is provided in the ETX® Design Guide. Refer to the documentation for additional
information.
Configuration:
The floppy-disk controller uses I/O, IRQ, and direct memory access (DMA) resources. These resources are
allocated by BIOS during POST configuration and are compatible with common PC/AT settings. You can
change some parameters of the parallel-communication interface through the BIOS setup.