Filter
Top Products
User Manual version 2.1
OPEN (660) 120/140/150
3-31
Method 2 with metal fixture A
1. Cut a window of the same size of the OPEN
120/140/150’s flat panel display on the system
enclosure and make necessary fixed holes on it.
2. Before inserting the OPEN system into the system
enclosure, make sure all the hardware jumpers and
necessary software are installed.
3. Get a glass or acrylic transparent piece of the size
slighter larger than the cut window. Glue the
transparent piece to the cut window verge of the
system enclosure to prevent dust and water in. It is
suggested that the crevice between the LCD panel
display and transparent piece not to exceed 1mm.
4. Fix the OPEN system to the cut window of the system
enclosure with the provided metal fixture A (refer to
Sec. 1.4.2). Be sure to align the cut window to the
OPEN system’s flat panel display.
Note: Method 1 is easier than method 2. If the system is
to be exposed in an environment with constant vibration,
even slight vibration, then method 2 is recommended.
System enclosure
Fixture A
System enclosure
Fixture A
Fixture on system enclosure