Filter
Top Products
Raptor AT – Installation Guide
18
1st Boot Device
2nd Boot Device
3rd Boot Device
4th Boot Device
These options set the drive boot sequence that Raptor AT
attempts to boot from after AMIBIOS POST completes. The
settings are Disabled, 1st IDE, 2nd IDE, 3rd IDE, 4th IDE,
Floppy, ARMD-FDD, ARMD-HDD, ATAPI-CDROM, SCSI,
Network and I2O. The default is:
1st Boot Device - Floppy
2nd Boot Device - 1st IDE-HDD
3rd Boot Device - ATAPI-CDROM
4th Boot Device - Disabled
Try Other Boot Devices
Set this option to Yes (default) to instruct AMIBIOS to attempt
to boot from any other drive in the system if it cannot find a boot
drive among the drives specified in the 1st, 2nd, 3rd and 4th
Boot Device options.
Initial Display Mode
Set this option to BIOS (default) to obtain the normal boot-up
screen. Set to Silent to obtain the customized graphic boot-up
screen.
Floppy Access Control
This option selects usage right from the floppy drive. The setting
is either Read/Write (default) or Read-Only.
Hard Disk Access Control
This option selects usage right from the hard disk. The setting is
either Read/Write (default) or Read-Only.